Cy7c68013a Driver Windows 7

by

#boring_logic A 16-channel logic analyzer based on CY7C68013A MCU. All hardware files are located in 'hardware' directry, including shematic, PCB, gerber files, and BOM. R0A is an alpha version, and R01 is the final release. In 'firmware' directry there are two EEPROM firmware files support Saleae Logic 8 and USBee AX Pro software.

8 Cypress USB-Serial Windows Driver Installation Guide, Doc. 001- 87770 Rev *E Start Windows Update Search in Windows 7 Follow these steps to start the search in Windows 7 operating system: 1. Connect the USB-Serial device to the machine 2. Open Device Manager. To open Device Manager, click Start.

Firmwares are found from internet and only used for study. To burn the firmware into EEPROM: • Step1. Install driver in CypressTools Drivers CyLoad for CY7C68013A with blank EEPROM.

Run CypressTools bin CyConsole.exe and open options --> EZ-USB Interface. Select S EEPROM and choose the.iic file.

• (Note: Download a CySuiteUSB tool with newest version from Cypress website if the tools in firmware directory are no longer compatible with your OS) When you want to reburn the EEPROM, just disconnect the jumper and redo from Step1 to Step3. #For Windows7: Need to disable driver signature by pressing 'F8' key before loading the OS. Install CySuiteUSB and change the VID & PID numbers in INF driver file to match your device. Device VID & PID can be found in the windows device manager.

(CY7C68013A/14/15/16A) is a low power, highly integrated USB 2.0 microcontroller. This chip is a General Programmable Interface (GPIF™) that is supposed to ease the development of USB devices such as keyboards, mouses (mice!), flash drives, etc.

The board that I ordered is a development board from AliExpress for $4.60 and I was really impressed with its quality. There are 2 variants, one with one jumper & another with 2 jumpers. Both comes with a on/off switch and a RESET push button. Best usb password cracker.

The board also has an EEPROM (ATMEL 24C128 on my board) which is used to hold the VID/PID/DID of the device - this is for the host to identify the device to determine the correct driver. My board was of the 2 jumper model & I think both are the same. J1 is to connect/disconnect 2 LEDs from Vcc - these LEDs are connected to D0 & D1 J2 controls the high address bit of the EEPROM making it appear at I2C address 0xA0 or 0xA2 depending on the jumper. The FX2LP is designed with a unique feature that allows the firmware to be loaded to the chip RAM either from the host or from the EEPROM. Here we will be discussing a very interesting firmware that converts this $4.60 board into a logic analyzer!

Is a portable, cross-platform, Free/Libre/Open-Source signal analysis software suite. It supports a variety of devices & boards (logic analyzers, oscilloscopes, digital multi-meters. Etc.) Sigrok GUI frontend is called and this is application that we'll be using. To have the board working with PulseView we need the correct Windows driver - I downloaded it from.

Windows

The driver will be recognized as: Cypress FX2LP No EEPROM Device. This driver is probably not going to work with PulseView & we have to install a generic Windows USB driver using, which is an application that is installed with PulseView. After installing the Cypress driver, run Zadig & from the Options menu make sure that 'List all drivers' is checked. Select the Cypress driver & press the button. It may take a long time to install but eventually it will finish. Now PulseView should be able to detect & use the board.